Bit |
DIAG_STATUS |
NAMUR NE 107 |
---|---|---|
31 |
F: failure Status (Fehlerstatus) |
|
30 |
C: Function check (Funktionskontrolle) |
|
29 |
O: Out of specification status (außerhalb der Spezifikation) |
|
28 |
M: Maintenance required status (Status Wartung erforderlich) |
|
27 |
Faults in electronics (Elektronik defekt) |
F |
26 |
Faults in sensor or actuator element (Messaufnehmer defekt) |
F |
25 |
Installation, calibration problem (Installations-/ Justierproblem) |
C |
24 |
Out of service (Außer Betrieb) |
C |
23 |
Outside sensor limits (Außerh. Grenzwerte) |
O |
22 |
Environmental conditions, out of device spec. (Umgebungsbed. außerh. Spezifikation) |
O |
21 |
Fault Prediction: (Fehlervorhersage) Maintenance required (Wartung erforderlich) |
M |
20 |
Power is critical low: maintenance short term (Leere Batterie: Wartung erforderlich.) |
F M |
19 |
Power is low: maintenance Iong term (Schwache Batterie: Wartung bald erforderlich) |
M |
18 |
Software update incomplete (Software-Update unvollständig) |
C |
17 |
Simulation is active (Simulation aktiv) |
C |
16 |
Faults due to process influence (Fehler durch Beeinflussung) |
C |
15 |
Faults due to non-compliance with operation conditions (Fehler durch von Betriebsbedingungen) |
F |
14 |
Other faults (Andere Fehler) |
F |
13 |
Reserviert für Baseline-Geräteprofil |
|
12 |
Reserviert für Baseline-Geräteprofil |
|
11 |
Reserviert für Baseline-Geräteprofil |
|
10 |
Reserviert für Baseline-Geräteprofil |
|
09 |
Reserviert für Baseline-Geräteprofil |
|
08 |
Herstellerspezifisch, nur für GS01: Optical beam block fault (Lichtstrahl blockiert) |
F M |
07 |
Herstellerspezifisch, nur für GS01: Attenuated optical beam (Lichtstrahl abgeschwächt) |
M |
06 |
Herstellerspezifisch, nur für Polytron 6100 EC WL: Warm-up1 (Einlaufen 1) |
O |
05 |
Herstellerspezifisch, nur für Polytron 6100 EC WL: Calibration interval warning (Justierintervall) |
M |
04 |
Herstellerspezifisch, nur für Polytron 6100 EC WL: Sensor selftest warning (Sensorselbsttest) |
M |
03 |
Herstellerspezifisch, nur für Polytron 6100 EC WL: Network connectivity error (Netzwerkfehler) |
F |
02 |
Herstellerspezifisch |
|
01 |
Herstellerspezifisch |
|
00 |
Detail information available (Detailinformationen verfügbar) |